Total
3 CVE
| CVE | Vendors | Products | Updated | CVSS v2 | CVSS v3 |
|---|---|---|---|---|---|
| CVE-2025-20137 | 1 Cisco | 41 Catalyst 1000-16fp-2g-l, Catalyst 1000-16p-2g-l, Catalyst 1000-16t-2g-l and 38 more | 2025-08-05 | N/A | 4.7 MEDIUM |
| A vulnerability in the access control list (ACL) programming of Cisco IOS Software that is running on Cisco Catalyst 1000 Switches and Cisco Catalyst 2960L Switches could allow an unauthenticated, remote attacker to bypass a configured ACL. This vulnerability is due to the use of both an IPv4 ACL and a dynamic ACL of IP Source Guard on the same interface, which is an unsupported configuration. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass an ACL on the affected device. Note: Cisco documentation has been updated to reflect that this is an unsupported configuration. However, Cisco is publishing this advisory because the device will not prevent an administrator from configuring both features on the same interface. There are no plans to implement the ability to configure both features on the same interface on Cisco Catalyst 1000 or Catalyst 2960L Switches. | |||||
| CVE-2017-3881 | 1 Cisco | 323 Catalyst 2350-48td-s, Catalyst 2350-48td-sd, Catalyst 2360-48td-s and 320 more | 2025-04-20 | 10.0 HIGH | 9.8 CRITICAL |
| A vulnerability in the Cisco Cluster Management Protocol (CMP) processing code in Cisco IOS and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a reload of an affected device or remotely execute code with elevated privileges. The Cluster Management Protocol utilizes Telnet internally as a signaling and command protocol between cluster members. The vulnerability is due to the combination of two factors: (1) the failure to restrict the use of CMP-specific Telnet options only to internal, local communications between cluster members and instead accept and process such options over any Telnet connection to an affected device; and (2) the incorrect processing of malformed CMP-specific Telnet options. An attacker could exploit this vulnerability by sending malformed CMP-specific Telnet options while establishing a Telnet session with an affected Cisco device configured to accept Telnet connections. An exploit could allow an attacker to execute arbitrary code and obtain full control of the device or cause a reload of the affected device. This affects Catalyst switches, Embedded Service 2020 switches, Enhanced Layer 2 EtherSwitch Service Module, Enhanced Layer 2/3 EtherSwitch Service Module, Gigabit Ethernet Switch Module (CGESM) for HP, IE Industrial Ethernet switches, ME 4924-10GE switch, RF Gateway 10, and SM-X Layer 2/3 EtherSwitch Service Module. Cisco Bug IDs: CSCvd48893. | |||||
| CVE-2018-0161 | 1 Cisco | 15 Catalyst 2960l-16ps-ll, Catalyst 2960l-16ts-ll, Catalyst 2960l-24pq-ll and 12 more | 2025-01-27 | 6.3 MEDIUM | 6.3 MEDIUM |
| A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS Software running on certain models of Cisco Catalyst Switches could allow an authenticated, remote attacker to cause a denial of service (DoS) condition, aka a GET MIB Object ID Denial of Service Vulnerability. The vulnerability is due to a condition that could occur when the affected software processes an SNMP read request that contains a request for the ciscoFlashMIB object ID (OID). An attacker could trigger this vulnerability by issuing an SNMP GET request for the ciscoFlashMIB OID on an affected device. A successful exploit could cause the affected device to restart due to a SYS-3-CPUHOG. This vulnerability affects the following Cisco devices if they are running a vulnerable release of Cisco IOS Software and are configured to use SNMP Version 2 (SNMPv2) or SNMP Version 3 (SNMPv3): Cisco Catalyst 2960-L Series Switches, Cisco Catalyst Digital Building Series Switches 8P, Cisco Catalyst Digital Building Series Switches 8U. Cisco Bug IDs: CSCvd89541. | |||||